Warranty
Sparky CAs
firebox is
covered by a 5 year warranty
(Please refer to Installation &
Operating Instructions for full
details).
Wagener Stoves have over
40 years experience in the
heating industry and have been
members of the NZ Home
Heating Association for over
30 years.
Other Products
Manufactured by
Wagener Stoves
Wagener Stoves also design and
manufacture “Lion” Wetbacks, the
CookTop Wagener Stove, Butler
Multi High Performance Hot Water
Heaters, Traditional Style Slow
Combustion Wagener Fairburn
Cookers, Wagener Sparky and
Wagener Leon.
WAGENER STOVES "LION"
LTD
5 Allen Bell Drive, Kaitaia 0410
New Zealand
Phone: 09 408 2469
www.wagenerstoves.co.nz
At Wagener Stoves we are continually
improving our products and therefore
specifications and designs may change
without prior notice
2019
N E
W Z
E A L A N D M A D
E
Diagram C
Diagram B
3m
3m
3m
1m (min)
0.6m
or less
More than 3m
*increase flue
height as
needed to be
clear by 3m
Flue Installation
It is imperative that the connection between the flue and the
flue spigot is sealed using a recommended flue sealant. If an
offset bend is required it should be as steep as possible to
enable ease of cleaning. Extra flue height may be required to
compensate for any lack of draw through the bend.
more on the flue than on any other single component
We recommend 4.2 metres of flue.
4
COWL
200MM
OUTER
CASING
PERLIN
FLASHING
Inner casing
200mm above
roof line
100MM
FLUE PIPE
150MM
INNER
CASING
CEILING
PLATE
CERAMIC
CEILING
SPACER
NOGGING
Ash Hearth
Floor Protector
100mm
Flue Pipe
Flue Flange
Flue Shield
Flue collar
panel
WAGENER
Sparky
RU
4.2 Metres from above flue collar panel to top of flue pipe
The top of the flue system should be at least 1000mm above
the roof or at least 600mm higher than any obstacle or ridge
within 3 metres of the flue. The flue pipe shall extend
not less
than 4.6M ABOVE the top of the floor protector.
However a total minimum vertical height ABOVE the Wagener
Joints between sections of the flue pipes are push fitted so that
the upper section enters the bottom section and must be
SEALED using a flue sealant.
Each section should be secured to prevent separation using
three
stainless
steel self tapping screws or
three monel steel
rivets. Only flue
systems which comply with the AS/NZS 2918-2001 should be used.
Please follow flue manufacturers instructions on page 5 and 6
“100mm Free Standing Woodfire Flue Kit Installation”
Instructions’.
NB. Bird netting is available
designed 100/150/200 flue system with reduced sized flue
shield and ceiling plate for improved performance. However a
tested 100/200/250 system is compliant with the requirements
of the standard but may cool the flue and affect the
Roof line
CASING
COVER
1000mm
30mm
gap
2021
Sparky RU
The Wagener Sparky RU uses a 100mm diameter flue.
The performance of Wagener Sparky RU depends
as it is the draw on the flue that drives the Sparky RU.
Sparky RU of 4.2 metres is recommended for adequate draft.
Note: Wagener Sparky RU has been tested with a purpose
performance of Sparky RU.