1
ROSEDALE SMOKE CONTROL STOVE
INSTALLATION AND USER INSTRUCTIONS
Read these instructions carefully before installation and use.
These instructions should be retained by the user for future reference.
The Rosedale SC stove has a nominal heat output of 7.5kW. and a weight of 90 kg. The
flue gas mass flow is 5.8 g/s for mineral fuel and 5.4 g/s for wood logs. The mean flue gas
temperature directly downstream of the flue spigot at nominal heat output is 338
degrees C. The Rosedale SC has been approved by Hetas Ltd. as a closed appliance and
is capable of intermittent operation.
CO Alarms:-Building regulations require that whenever a new or replacement fixed solid
fuel or wood/biomass appliance is installed in a dwelling a carbon monoxide alarm must be
fitted in the same room as the appliance. Further guidance on the installation of the carbon
monoxide alarm is available in BS EN 50292:2002 and from the alarm manufacturer’s
instructions.
Provision of an alarm must not be considered a substitute for either installing the appliance
correctly or ensuring regular servicing and maintenance of the appliance and chimney
system.
WARNING
The stove must be installed to comply with Health and Safety at Work Act 1974to British
Standard BS 8303 and to all local Building Regulations, including those referring to
National and European standards. These need to be complied with when installing the
appliance.
Ensure that the flue pipe diameter is not less than the 150mm diameter outlet on the
appliance.
There must not be an extractor fan fitted in the same room as the Rosedale SC.
If there is a possibility of disturbing asbestos during the installation it is necessary to take
the appropriate steps to protect the installer. Fire cement is caustic and protective gloves
should be worn.
The chimney must be swept and examined for soundness and suitability before the stove is
installed. Remedial action should be taken if required, seeking expert advice if necessary.
Where the chimney is believed to have previously served an open fire installation, it is
possible that the higher flue gas temperature from a closed appliance may loosen deposits
