GSM-HOUSE INTERCOM UNIT
WAFER GSM-HOUSE PROGRAMMING
You can program the GSM-HOUSE with SMS commands using your phone. It is safe to do
so because in addition to the fact that other people may not know the number of the SIM inserted
in it, we also use a Password that makes it impossible for anybody who doesn't know it to access
the system by chance.
Remember that all commands must be CAPITAL LETTERS. Such as PWD not pwd, CAP
not Cap etc. Also Don't add spaces or any other character.
Some complicated Instructions,that cann’t be programmed by the phone SMS. That would
need to use the PC software to program and inquire the status of the terminal.
The following compand is used in the GSM-HOUSE :
#PWD
:
Password
#CAP
:
Change password
#WHL,SHL,PHL,QHL
:
White List (add or remove numbers)
#QUERY:
Query the number
#MODE:
Relay working mode
#GOT
:
Gate pulse time
#REPORT
:
Report status change
#REPLY
:
Reply enable or disable
#ALARM
:
Alarm information setting
#CSQ
:
Check Signal Quality
#STATUS
:
Check status
#DIAL:
Add or remove Intercom Dial numbers
#OUT:
Relay output control
Once an authorized user issue a command with an SMS, user will receive a confirmation
SMS with OK
SMS COMMAND LIST:
#PWD
Password
.
This command must always come first 6 digits as a password.
The initial password, when the device comes from the factory, is 123456.
In all the following examples will use 123456 as an example of password.
#CAP
Change Password
.
Use this command to change the password with a new one for your device
The #CAP command must be issued 2 times to be sure you don't digit a wrong one.
OF course it must be preceded by the old password.
For example, to change the password 123456 into the new password 333444 you need to send the
following SMS:
#PWD123456#CAP333444#CAP333444
Acknowledge SMS: PWD SETUP OK
If you wrote correctly, or an Error message if you made a mistake.
If the old password is error,then conformation would be : Error Old Password
If you input two different new password,then reply would be : Error New Password,Please Check
the input again.
