GSM-HOUSE INTERCOM UNIT
INSTALLATION
To install the GSM-HOUSE, you need to connect the 2 wires of the relay contact in parallel
with the gate opening button. The relay contacts can stand
30V 2A maximum
, this is enough for
its operation but
don't try to switch higher voltages or currents
. You should install the
GSM-HOUSE in a place with good GSM signal. Check it with a phone before proceeding with
the installation.
If it is to be installed in a weak signal,consider using the magnetic mount GSM
antenna
for better signal gain.
You should then insert the SIM Card of the operator you want to use with the right direction
according to the following pictures.
!Note! : You must remove the PIN request from the SIM before inserting it in the
unit
, otherwise the device will not work. In order to do so, insert the SIM in a mobile phone and
verify the SIM card to call other phone and send and receive the SMS).
Lock the SIM card in the right direction:
GSM-HOUSE also comes with additional 2 Input.The inputs can be used to generate alarms
when triggered. For examples,you can can connect the door or gate saftey beam output to the
GSM-HOUSE Alarm1 and Alarm2 input.
Before the following test,Connect the DC12V to the AC/DC power input terminal.
Lock the panel
Insert the key, gently press and turn the key left to pull out the front panel. Gently press the key
and turn it to the vertical position to lock the front panel and eject the key.
Please read this entire manual before installation
!Note!
Take EXTREME care with the Power line installation
In case of fault power connection will cause the default permanently.
To maximum reception, install the GSM antenna in a prominent elevated position if
possible, and vertically mounted.
The GSM unit requires mounting carefully with the lock for proper operation.
1.Slide back the SIM door and
lift it up
2.Slide the SIM Card into the
SIM door making sure that
the clipped corner of the SIM
card lines up with the clipped
corner of the SIM holder
3.Close the SIM door
4.Slide the SIM door to lock the
SIM card in place
