![background image](http://html1.mh-extra.com/html/wafer/gsm-house/gsm-house_manual_3119075009.webp)
GSM-HOUSE INTERCOM UNIT
Check the text set
#PWD123456#UDI?
Acknowledge:
UDI1:ABC1, UDI2:ABC2
#REPORT
Report the system status change
When setup to:
#PWD123456#REPORT=ON
Acknowledge
:
REPORT SET TO ON
Then any device status change would send the alarm SMS to Alarm01 number
#PWD123456#REPORT=OFF
Acknowledge
:
REPORT SET TO OFF
No report for the device status change
#PWD123456#REPORT?
You will receive the SMS reply: REPORT IS ON or REPORT IS OFF
Check the REPORT setting status
#CSQ
Check GSM signal quality
.
This command is useful to see what is the GSM network signal level your GSM-HOUSE is
receiving. It ranges from 0 to 32.You should have a signal above 12 to be sure of being able to
open the gate in any condition. Better if above 16. You should add an external antenna if this is
not the case.
#PWD123456#CSQ?
Acknowledge: CSQ IS 26
#MODE
Relay Operation Mode SETUP
#PWD123456#MODE0
Acknowledge
:
RELAY SET TO MODE0
#PWD123456#MODE1
Acknowledge
:
RELAY SET TO MODE1
If set to MODE0,that is Momentary pulse and If Config to MODE1,that is Ratchet relay
#STATUS
Check the config information of the terminal
#PWD123456#STATUS?
You will receive a Acknowledge SMS with:
ALARM1=OFF:SMS:12, ALARM2=OFF:SMS:10, GOT=05S, WHL=02, AIN1=HIGH,
AIN2=HIGH, BCPW=ON:70:80, CSQ=20, RELAY1=OFF, RELAY2=OFF
(ALARM1 and ALARM2 are the parameters setting, AIN1 and AIN2 are the input status,
BCPW is battery working and alarm status, Lower than 70% would alarm and Current has 80%
power )
#OUT
Control the Relay Output on or off
#PWD123456#OUT1=ON or
#PWD123456#OUT1=OFF
Acknowledge:OUT1 ON OK or OUT1 OFF OK
#PWD123456#OUT2=ON or #PWD123456#OUT1=OFF
Acknowledge: OUT2 ON OK or OUT2 OFF OK