GSM-HOUSE INTERCOM UNIT
#GSM Intercom function and config command
1. Add the phone number for the inter calling
#PWD123456#DIAL01=180122333 and
#PWD123456#DIAL02=181323344
Reply: DIAL01 SET TO 122333 OK
Reply: DIAL02 SET TO 323344 OK
2. Inquiry the intercom calling number in the memory
#PWD123456#DIAL=ALL?
You will receive a Acknowledge with: DIAL IS 180122333:181323344:0000:0000:0000
3. During talking,user can press phone keypad number “1” or “*” to control the relay output1 and
press the number “2” or “#” to control the relay output2
The following is the function of GSM-KEY.
#WHL
White List
.
This is the command that you will use most. it is used to add or remove numbers that are enabled
to open the gate into the White List. You can add up to 200 numbers in the list. Every position
must be indicated in the command and we advise you to keep a list written somewhere to know
which numbers are in and in which position.
• To add a number, the syntax of the command is the following:
#PWD123456#WHL01=61143815
Acknowledge would be : WHL01 SET TO 61143815 OK
Where 01 is the position in the list and 61143815 is the number enabled.
Please note that it is possible to program up to a maximum of 10 digits for a number. If it has
more digits you should use the rightmost ones. For example, if your number is 33446665555 you
should program 3446665555. If your number appears as +85261143815 you should not program
the country code (+852). If your number has only 9 digits or less, it is not a problem. The
important thing is that you don't exceed 10 digits.
• To check which is the number in a place of the list:
#PWD123456#WHL01?
Acknowledge
:
WHL01 IS 61143815 OK
• To erase a number:
#PWD123456#WHL01=0000
(or you can write over it another number you wish to add)
Acknowledge : WHL01 SET TO 00000000
List All numbers in the List
#PWD123456#WHL=ALL?
( Only for PC COMMAND, Cann’t use the SMS to read back)
Acknowledge :
WHL01 IS xxx
WHL03 IS xxx
WHL08 IS xxx
……
Through the simple DIAL Command above, then already can use the INTERCOM
function. That is, by calling the button to call the set number
