Fitting the camera
PerfectView
44
Creating a through-hole for the camera connection cable (fig.
k
,
page 9)
I
Note
If possible, use available openings, such as ventilation grilles, to
feed the connection cables through. If there are no existing open-
ings, you must drill a hole with a 13 mm diameter. Check
beforehand that there is sufficient space for the drill head to come
out on the other side.
➤
Drill a hole of Ø 13 mm near the camera.
➤
Deburr all drill holes that have been made in the sheet metal and apply
rust-protection.
➤
Place cable sleeves in all sharp-edged ducts.
Attaching the camera and camera guard
a
Caution!
Never mount the camera without the additional camera guard. To
mount the camera guard, only use the M3 x 8 mm screws provid-
ed. Longer screws will damage the camera.
➤
Push the camera guard (fig.
8
4, page 5) over the camera in such a way
that:
– The fixing hole of the camera guard (fig.
l
, page 9) is over the 3-mm
thread of the camera.
– The two other fixing holes (fig.
m
, page 9) are over the 4-mm threads
of the camera.
➤
Secure the camera guard with the two M3 x 6 mm screws in the hole
(fig.
l
, page 9).
➤
Push the camera into the bracket (fig.
m
, page 9).
a
Caution!
Only use the screws supplied to mount the camera in the camera
holder. Longer screws will damage the camera.
➤
Secure the camera
loosely
with the four M4 x 10 mm screws in the two
other fixing holes (fig.
m
, page 9).
The camera is now centred.
_RV-33.book Seite 44 Donnerstag, 30. November 2006 1:41 13
