PerfectView
Fitting the camera
43
If you want to screw on the camera with self-tapping screws (fig.
i
,
page 9)
a
Caution!
Self-tapping screws may only be fastened to steel metal with a min-
imum thickness of 1.5 mm.
➤
Drill 4 mm diameter holes at the points you just marked.
➤
Deburr all drill holes and apply rust-protection.
➤
Stick the double-sided adhesive insulation (fig.
8
3, page 5) to the as-
sembly side of the bracket.
The insulation plate serves as a seal and protects the paint.
➤
Screw the camera bracket on with the 5 x 25 mm self-tapping screws.
If you would like to attach the camera with threaded screws fitted
through the construction (fig.
j
, page 9)
a
Caution!
When tightening the nuts, make sure that they cannot be pulled
through the construction.
You may have to use bigger washers or plates.
➤
Drill 5.5 mm diameter holes at the points you just marked.
➤
Deburr all drill holes and apply rust-protection.
➤
Stick the double-sided adhesive insulation (fig.
8
3, page 5) to the as-
sembly side of the bracket.
The insulation plate serves as a seal and protects the paint.
➤
Screw the camera holder on with the M5 x 20 mm threaded screws.
Depending on the thickness of the construction, you may require longer
threaded screws.
_RV-33.book Seite 43 Donnerstag, 30. November 2006 1:41 13
