PerfectView
Safety and installation instructions
33
e
Warning!
To prevent short circuits, always disconnect the negative terminal
of the electrical system before working on it.
If the vehicle has an additional battery, its negative terminal should
also be disconnected.
e
Warning!
Inadequate cable connections can cause short circuits, resulting in:
– Cable fires
– The airbag being triggered
– Damage to electronic control equipment
– Electrical malfunctions (indicators, brake light, horn, ignition,
lights)
Please therefore observe the following instructions:
z
When working on the following cables, only use insulated cable terminals,
plugs and flat push-on receptacles:
– 30 (direct supply from positive battery terminal)
– 15 (connected positive terminal, behind the battery)
– 31 (return cable from the battery, earth)
– 58 (reversing light)
Do
not
use terminal strips.
z
Use a crimping tool (fig.
1
10, page 3) to connect the cables.
z
Screw the cable for connections to cable 31 (earth)
– Screw on the cable using a cable terminal and serrated washer to one
of the vehicle's earth bolts or
– Screw the cable to the bodywork using a cable terminal and a self-tap-
ping screw
Make sure there is a good earth connection.
If you disconnect the negative terminal of the battery, the entire data stored
in the volatile memories will be lost.
z
The following data must be reset, depending on the vehicle equipment op-
tions:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the corresponding
operating manual.
_RV-33.book Seite 33 Donnerstag, 30. November 2006 1:41 13
