Waeco CoolMatic HDC-150, Installation And Operating Manual

Page: 36 / 192

Installing the refrigerator HDC-150
36
➤
Determine the required cross section of the cable in relation to the cable
length according to fig.
c , page 9.
Key for fig.
c
, page 9
A
NOTICE!
Make sure the polarity is correct.
➤
Before starting up the device for the first time, check whether the operat-
ing voltage and the battery voltage match (see type plate).
➤
Connect the refrigerator
– as directly as possible to the poles of the battery or
– to a plug socket which is fuse protected with at least 15 A (at 12 volts)
or 7.5 A (at 24 volts).
Connecting to a 230-volt mains supply
D
DANGER! Danger of fatal injury!
 Never handle plugs and switches with wet hands or if you are
standing on a wet surface.
 If you are operating your cooling device on board a boat with a
mains connection of 230 volts from the land, you must install a
residual current circuit breaker between the 230 volt mains
supply and the cooling device.
Seek advice from a trained technician.
➤
Use the connection cable for the AC mains supply.
Coordinate axis Meaning Unit
l Cable length m

Cable cross section mm²
_HDC150.book Seite 36 Donnerstag, 1. März 2012 11:59 11