Waeco CoolMatic HDC-150, Installation And Operating Manual

Page: 32 / 192

Safety instructions HDC-150
32
A
NOTICE!
 Ensure that the ventilation vents are not covered.
 Keep the drainage outlet clean at all times.
 Check that the voltage specification on the type plate is the
same as that of the power supply.
 Do not open the refrigerant circuit under any circumstances.
 Never transport the device in a horizontal position, so that no oil
can leak out of the compressor.
 Set up the device in a dry location where it is protected against
splashing water.
 Do not place it near naked flames or other heat sources (heat-
ers, direct sunlight, gas ovens etc.).
 Food may only be stored in its original packaging or in suitable
containers.
 The appliance is not suitable for the storage of caustic materials
or materials containing solvents.
 Disconnect the cooling device and other electric consumers
from the battery before you connect the battery to a quick charg-
ing device.
Overvoltage can damage the electronics of the device.
2.2 Operating the appliance safely at 100 V–240 V
!
CAUTION!
 Before starting the device, ensure that the power supply line
and the plug are dry.
A
NOTICE!
 Only use the cable supplied to connect the appliance to the AC
mains.
 Never pull the plug out of the socket by the cable.
 Check that the voltage specification on the type plate is the
same as that of the power supply.
_HDC150.book Seite 32 Donnerstag, 1. März 2012 11:59 11