Wacker Neuson PTS 4V, Operator'S Manual

Page: 24 / 60

wc_tx003330gb.fm
24
Operation PTS 4V
4.4 Starting
Follow the instructions below and read starting and stopping instuctions found in
the engine owner’s manual.
1. Open the fuel valve (b1) .
2. If the engine is cold, pull out the choke control (a1) . If the engine is hot, push in
the choke control (a2) .
3. Move the throttle control to the fast position (c1) .
4. Turn the key switch to the start position (d3) and hold it until the engine starts.
NOTICE: Do not crank engine longer than 15 seconds at a time. Extended
cranking can damage the starter motor.
5. To start the engine using manual start:
„
Turn the key switch to the run position (d2) .
„
Rapidly pull the starter rope (e) to start the engine.
„
Leave key in run position (d2) while engine is running.
Note: The engine is equipped with a low oil protection system, which does not
allow the engine to start if the oil level is low. This device will not protect the engine
if a low oil level occurs while running. The switch opens on a pressure rise of 4 psi
±1.5 psi.
6. Push the choke in as the engine warms (a2) .
7. Keep the engine throttle in the fast position while operating pump.
4.5 Stopping
1. Reduce engine RPM by moving the throttle completely to the idle position (c2) .
2. Turn the engine switch to the stop position (d1) .
3. Close the fuel valve (b2) .