Wacker Neuson G 240, Operator'S Manual

Page: 82 / 254

wc_tx003229gb_FM10.fm
82
Mobile Generator
Working with Basler Controller
8.10 Changing the Low Fuel Pre-Alarm Setting
Requirements

Machine stopped

Start switch in REMOTE START
Note: Internal programming of the genset controller, or closed connections to a
remote start switch, may cause the machine to start unexpectedly. Be prepared for
the engine to start even with the engine start switch in the REMOTE START
position.
Background The low fuel pre-alarm setting may be changed if desired. The value shown by the
genset controller is the percentage of fuel remaining in the fuel tank. The range
allowed by the genset controller is 10–100.
Procedure Perform the procedure below to change the low fuel pre-alarm setting.
1. Press the right arrow button (1) to access the MAIN MENU.
2. Using the up/down arrow buttons (2, 3) highlight SETTINGS. Then, press the
right arrow button.
3. Highlight ALARM CONFIGURATION. Then, press the right arrow button.
4. Highlight PRE-ALARMS. Then, press the right arrow button.
5. Highlight the LOW FUEL LEVEL. Then, press the right arrow button.
6. Highlight the THRESHOLD. Then, press the check mark button (5) .
7. If you are not logged in, enter the password “OP”. Press the check mark button.
This procedure continues on the next page.