Wacker Neuson Dumper 5001, Operator'S Manual

Page: 69 / 130

BA 5001-6001 US – Edition 1.2 * 6001b330.fm
3-37
Operation
3.22 Towing
NOTICE:
Improper towing may damage the machine.
☞
The dumper is equipped with towing gear at the rear and a towing lug at the front. Only
this equipment may be used for towing.
☞
Open the high-pressure circuit before towing the machine.
Opening the high-pressure circuit
There are two HP pressure limiting valves on the pump under the floor panel, one on the
upper left and the other on lower left.
Proceed as follows:
☞
Slacken locknut ws 14 (part 2) and unscrew it to the end of the screw.
☞
Screw in the screw with an allen key ws 4 part 1 until it is flush with the nut
☞
Retighten the locknut.
☞
You can now slowly tow the machine (max. 1 kph/0.62 mph) over a short distance
(max. 1 km/0.62 miles).
☞
Then put the valves back into operation again! Proceed in the reverse order to do this
(unscrew the screw as far as it will go).
2
1
Fig. 60: Opening the high-pressure circuit