Troubleshooting the Burner
Cub 200/300
46
ghi_tx001207gb.fm
6.4
Checking Output Voltage from the Control Board
Requirements
Multimeter
Procedure
Perform the procedure below to check output voltage from the control board for the
fuel system.
1. Start this procedure with the machine disconnected from the power supply.
2. Remove the screws
(a)
that hold the control panel and pull the control panel
from the machine.
3. Remove the cover
(b)
from the control panel.
4. Connect the machine to the power source.
5. Turn the machine on. If the machine is in a fault condition, press the RESET
(c)
button on the control panel.
This procedure continues on the next page.
WARNING
Electric shock hazard. High voltage exists inside the control panel when the power
cord is plugged into a power supply. Electric shock can cause serious injury or
death.
f
Use extreme care and appropriate arc flash avoidance techniques when mea-
suring live, high voltage.
Summary of Contents for Cub 200
Page 1: ...Repair Manual Indirect Fired Air Heater Cub 200 Cub 300 0179422en 001 1009 0 1 7 9 4 2 2 E N...
Page 4: ...Foreword Cub 200 300 ghi_tx001204gb fm 4...
Page 15: ...Cub 200 300 Operation ghi_tx001205gb fm 15 Notes...
Page 59: ...Cub 200 300 Schematic ghi_tx001210gb fm 59 7 Schematic 7 1 Cub 200 Cub 300 Schematic...
