Cub 200/300
Burner Setup
ghi_tx001317gb.fm
25
3.7
Checking and Adjusting the Fuel Pressure
Requirements
Pressure gauge
British Parallel Thread (BPT) adapter
Procedure
To check and/or adjust the fuel pressure, carry out the following procedure:
1. Shut down the machine and allow it to cool.
2. Disconnect the power cord from the power source.
3. Open the access panel
(a)
.
4. Remove the threaded plug
(b)
from the pressure test port using an allen
wrench. Set the plug in a safe location to be re-installed later.
5. Install a pressure gauge with BPT adapter
(d)
in the pressure test port.
6. Reconnect the power source.
7. Start the machine
.
With the machine running and access panel closed, observe
the fuel pressure on the gauge
(c)
. For the correct pressure, refer to the
Technical Data
charts in this manual.
8. Shut down the machine.
This procedure continues on the next page.
ghi_gr006919
b
Summary of Contents for Cub 200
Page 1: ...Repair Manual Indirect Fired Air Heater Cub 200 Cub 300 0179422en 001 1009 0 1 7 9 4 2 2 E N...
Page 4: ...Foreword Cub 200 300 ghi_tx001204gb fm 4...
Page 15: ...Cub 200 300 Operation ghi_tx001205gb fm 15 Notes...
Page 59: ...Cub 200 300 Schematic ghi_tx001210gb fm 59 7 Schematic 7 1 Cub 200 Cub 300 Schematic...
