T01126en.fm
51
Starting up
Notice:
Do not pull out the starter rope more than 50 cm (20") and let
it rewind slowly by hand, not letting it go.
Depress decompression valve (
5
) again.
Press the multifunction switch (
42/6
) to the "I" position.
Pull the starter rope again until the engine runs.
Once the engine is running, tip the throttle lever (
42/9
) so that the lock
button (
42/7
) snaps out and the engine idles.
7.6.2 Warm start
As described under cold start, however without pressing the multifunc-
tion switch (
42/6
) in the choke position.
7.7
Turning off the engine
Press the multifunction switch (
9
) down to the "Stop" position.
7.8
Readjusting the idle speed
NOTE:
The cut-off saw is equipped with a speed limiting elec-
tronic ignition. In addition, the carburetor has a fixed
nozzle that cannot be adjusted.
The idle speed has been factory set to approx. 2,500 rpm; however,
the run-in procedure of a new machine requires a slight readjustment
of the idle speed.
Adjustments to the adjusting screws (L) and (H) may only be made by
an authorised Wacker Neuson service centre. Accordingly, the holes
for the two screws are sealed shut.
44
