Starting up
T01126en.fm
42
7.1
Attaching the cutting blade
Set the cut-off saw onto a sturdy base and carry out the following as-
sembly steps:
Check the cutting blade for damage. See SAFETY IN-
FORMATION.
Unscrew the screw (
9
) and remove the
clamping disc (
8
). Set the cutting blade (
5
) onto the shaft (
7
).
NOTE:
The arbor diameter of the cutting blade must precisely fit the
shaft. If the arbor diameter is larger, you must use an adapter ring (*).
NOTICE:
If you are using diamond-edged cutting blades, make sure
you observe the attached rotational direction mark!
Set the clamping disc (
8
) onto the shaft, screw in together with the
screw (
32/9
) and tighten by hand.
Turn the cutting blade slowly until you can see the locking bore of the
V-belt pulley bolt through the gear arm hole (
10
).
Press the offset screwdriver (
2
) all the way in. The shaft is now
blocked.
Firmly tighten the screw with the combination wrench (
1
).
NOTE:
Firmly tighten the screw to 30 + 2 Nm (22 + 1.5 ft.lbs.), other-
wise the cutting blade may slip while cutting.
32
33
