DW Guillotine 208
40
Part No. 29-MAN-00, Rev. A
E.H. Wachs
Figure 3-28. Adjust the wire tension knob to set the
tension gauge to the
SET
position.
Do not operate the saw more
than 15 seconds without
water or coolant. Heat from
the wire will damage the
wheel liners.
9.
Power on the HPU and enable flow to the saw. Turn
the ON/OFF knob to the ON position to operate the
saw briefly (a few seconds), then turn the saw OFF.
This will seat the cutting wire securely on the wheels.
10.
Re-adjust the wire tension knob to reset the tension
gauge to the
SET
position.
M
AKING THE
C
UT
Pre-Operation Checks
1.
Do not use the machine where heat or sparks might
cause a risk of fire or explosion.
• Do not use the machine in an explosive environ-
ment.
• Do not use the machine to cut pipe that contains
explosive contents.
2.
Check that the machine is securely mounted to the
pipe.
• The mounting chain should be as tight as you can
get it.
CAUTION
