149
21. Holding bracket (optional)
The holding bracket is used to accommodate drive units with a 23 mm diameter Euronorm collar. This
enables the use of devices, such as drills, routers and high-frequency spindles on a WABECO milling
machines.
Like the standard milling head, the holding bracket can be swivelled by 90 degrees to the left or the
right.
(see chapter: “Swivel milling head”)
21.1 Mounting the holding bracket to the milling machine
For machines that are fitted with the holding bracket at the factory, mounting will not be required.
Attention should be paid to ensure that the index bolt, unlike the standard milling head, is attached to
the right side of the holding bracket.
If the holding bracket is to be subsequently fitted to the machine, this will by default replace the milling
head mounted on the milling machine.
To mount the holding bracket, first remove the index bolt as described in
chapter: “Swivel milling
head”
. Then fully unscrew the hexagonal screw (2) and hexagonal nut (3). The milling head can then
be removed carefully and replaced by the holding bracket.
To secure the holding bracket, fit and screw the hexagonal screw (2) and hexagonal nut (3) back into
place far enough that the holding bracket can still be swivelled.
Then align the holding bracket and tighten the hexagonal screw (2) and hexagonal nut (3) fully.
The index bolt for quickly aligning the milling head/holding bracket may continue to be used. The cone
boring necessary for this must be made by the client in the holding bracket or vertical skid. For this
reason, the holding bracket has a pilot drilled hole on the right side.
Summary of Contents for CC-F1200 high speed
