WABECO CC-D6000 hs, Operating Instructions Manual

Page: 50 / 168

50
12. Tool skid – Transverse skid
The tool skid is positioned, at the front, on a prismatic guide and, at the rear, on a flat guide. The skid
is held onto the bed from below with the guide bar (9) and can be set to without play using the setting
bar (12).
If adjustment to the setting bar (12) is required, please proceed as follows:
1. Undo the hexagonal nuts (11)
2. Using an Allen key, tighten the threaded pins (10) in such a way that the skid is still able to move
easily.
3. After setting, tighten the hexagonal nuts (11) back up again
Clamping for face turning and cutting work.
Use the Allen head screw (6) to clamp the clamping piece (8) against the underside of the prismatic
guide. The tool skid can no longer be moved in the longitudinal direction.
The dovetail guide of the transverse skid can be adjusted.
If adjustment is required, please proceed as follows:
1. Undo the hexagonal nuts (5)
2. Using an Allen key, tighten the threaded pins (7) in such a way that the skid can still be moved
easily using the ball crank (1).
3. After adjustment, tighten the hexagonal nuts (5) back up again
Any axial play of the spindle (13) in the spindle bearing (14) that may occur, can be adjusted.
If adjustment is required, please proceed as follows:
1. Undo the threaded pins (3)
2. Rotate the dial (2) clockwise in such a way that no axial play remains
3. Tighten the threaded pins (3) back up again
4. After adjustment, the spindle (13) should still be easy to turn