WABECO CC-D6000 hs, Operating Instructions Manual

Page: 52 / 168

52
13. Tool skid – Longitudinal skid
■
The longitudinal skid is secure to the transverse skid upper section with the clamping ring (3).
■
After undoing the two hexagonal nuts (5) the longitudinal skid can be slid or turned on the
transverse skid.
■
The rotation is, for example, suitable for turning short tapers.
■
In order to accurately read this setting, a scale is engraved on the guide ring (4).
■
The zero mark is located on the transverse skid upper section.
The dovetail guide of the longitudinal skid can be adjusted.
If adjustment is required, please proceed as follows:
1. Undo the hexagonal nuts (2)
2. Using an Allen key, tighten the threaded pins (1) in such a way that the skid can still be moved
easily using the ball crank (7)
3. After setting, tighten the hexagonal nuts (2) back up again
Any axial play of the spindle (8) in the spindle bearing (11) that may occur, can be adjusted.
If adjustment is required, please proceed as follows:
1. Undo the threaded pins (9)
2. Rotate the dial (6) clockwise in such a way that no axial play remains
3. Tighten the threaded pins (9) back up again
4. After adjustment, the spindle (8) should still be easy to turn
To read off the distance of travel of the longitudinal skid, there is a scale ring (10)
■
One mark on the scale corresponds to an adjustment of 0.05 mm. Since the longitudinal skid does
not work with diameters, this 0.05 mm corresponds to the actual distance.
■
One turn of the ball crank (7) corresponds to a distance of 2 mm.