39
Planning and performing the TailGUARD™ installation
After installing the components and configuring the parameters for the ECU with the aid of the parameter set provided
by WABCO, the system is put into operation with the TEBS E Diagnostic Software.
In some cases, it may be necessary to first experimentally determine the appropriate mounting positions for the
ultrasonic sensors during installations so changes can be made. The TailGUARD™ parameterisation must then be
adapted accordingly in each case.
This is done by adjusting the parameter set based on a documentation for the new sensor positions, which can be
carried out by either WABCO
or the vehicle operator. In the latter case, however, a PIN 1 is required as access authorisation for this advanced
function. A PIN 1 authorisation can be acquired by attending a corresponding Trailer EBS E training course at
WABCO.
Summary of Contents for TAILGUARD
