Instruction manual |
15
8.6 Installing the LED housing
All models except IT406 FL4D
1
Insert the connector plug into the connector jack.
2
Push the LED housing gently into the holes of the illumination unit.
(Fig. 9)
IT406 FL4D
The LED of the IT406 FL4D is already pre-installed on the
illuminator. No operation is therefore necessary. (Fig. 10)
8.7 Installing color filters
Remove the filter holder, then install the color filter you need. (Fig.
11 - 12)
1
Mount the color filter flat as shown in (1), checking that they are
not tilted.
If the color filter is tilted or otherwise out of place
(2)
, it may fall.
Color filters can be stacked in the holder. This allows to install as
many filters as needed, as long as the whole thickness is less than
11 mm.
FIGURE 9
FIGURE 12
FIGURE 10
FIGURE 11
1
2