Information furnished by VubIQ is believed to be accurate and reliable. However, no responsibility is assumed by VubIQ for its use, nor for any infringements of patents or
other rights of third parties that may result from its use. Specifications subject to change without notice. No license is granted by implication or otherwise under any patent
or patent rights of VubIQ. Trademarks and registered trademarks are the property of their respective owners.
VuTxWGM3.7.02.13
VubIQ, Inc.
+1-949-226-7185 [email protected]
9231 Irvine Blvd, Irvine, California 92618 USA www.vubiq.com
11
The Temperature/Synth box monitors the board temperature and the RF module
temperature in ºC. The synth status section indicates the synthesizer lock status and
the band tuning status.
Power supply voltages are monitored in this box.
Note: the 5 volt supply is measured from the USB source and typically runs at about
4.1 to 4.4 V.
The Control box (RX shown) provides basic controls for the board which includes
following functions:
•
Power on/off for the waveguide module
•
Reload parameters from FLASH memory
•
Save current parameters to FLASH memory
•
Refresh GUI display
Note: upon power up, the last set of parameters saved to FLASH memory are used
to configure the transmitter or receiver.
