Cleaning the outside
To clean the outside of the appliance, follow the
instructions below:
• disconnect the appliance from the mains;
• only use a soft slightly damp cloth (fig. 37);
• do not use abrasive and/or corrosive products (fig. 38);
•
do not use a rough and/or soaking cloth; any water
that gets inside the appliance could cause serious
damage.
Initial settings
(for installer only)
There are two ways for the installer to make the initial ap-
pliance settings:
• Remote mode using the (RF) remote control unit and
radio module.
• Appliance mode using the trimmer and dip-switch.
In addition to altering the speed settings, the initial
configuration will also include the adjustment of the air
inlet and outlet openings to and from the rooms served.
Appliance/remote control coupling
Each remote control must be initialised before use. This
activity is entrusted to the installer (for remote controls sold
separately from the product), or factory set (for remote
controls sold with the product).
The activity comprises the following steps:
a. turn the power off for at least 30 sec.;
b. turn the power back on;
c. within 60 sec. perform the procedure described below.
In detail, holding down the
ENTER key
for at least 3
seconds, the appliance will couple with the remote control.
Completion of coupling will be confirmed by an acoustic
signal (constant 3 second BEEP) from the remote control
itself.
Using the remote control/radio mode
(fig. 39
The initial appliance settings can be made by means of
the (RF) remote control unit and external radio module
that do not come as standard with the appliance.
N.B. Some of the functions included on the remote
control unit do not apply to this appliance.
ENGLISH
37
38
28
88:88
SUMMER
MAN
AUTO
T(°C) CO2(ppm) RH(%) O
Mo Tu We Th Fr Sa Su
DISPLAY
TIMER MODE
SET NEXT
ENTER
39
Summary of Contents for VORT HR 200
Page 27: ...clean the heat exchanger re t the heat exchanger gs 34 35 36 ENGLISH 31 32 33 27 34 35 36...
Page 34: ...34 NOTE...
Page 35: ...35...
