Items supplied
The main appliance components are as follows:
• an outer casing in painted sheet metal, a rear panel in
galvanized shhet metal; the casing houses the
intake/outlet hose connections and the electrical
connection box; the casing also houses the internal
components and heat exchanger in an air tight
housing;
• internal ducts in EPP (expanded polypropylene) that
distribute flow of air while maximising heat insulation
and minimising losses.
• the plastic resin, counterflow, heat exchanger whose
particular shape guarantees the highest possible
efficiency in terms of heat exchange (up to 93%);
• 2 filters with G3 level particle retention;
• 2 cover slides in ABS;
• 2 brushless motors connected to centrifugal fans;
• the electronic circuit board that processes power
supply, appliance commands and controls;
• a temperature sensor that is essential to stop the
formation of frost on the heat exchanger;
Accessories supplied
The accessories supplied as standard include:
• 1 x condensation drainage hose coupling
• 1 x condensation drainage hose;
• 2 x rawlplugs with hooks for wall-mounting the
appliance
Installation
The appliance must be installed according to the safety
regulations currently in force in the country of
destination, and the instructions provided by this
booklet.
Prerequisites
The appliance must be fitted to an internal surface or
wall of the home that is structurally sound enough to
bear its weight.
The ducts used for carrying ducting must be of the
correct size.
Ducts to and from the exterior must be thermally
insulated and not subject to vibration.
The 125 mm standard diameter inlet and outlet pipes
must be fixed to the corresponding spigots on the
appliance by means of clips or some other suitable
fastening system.
Under normal operating conditions, condensation
gathers at the bottom of the appliance. In order to
dispose of it, the small hose provided must be attached
to the coupling on the underside of the appliance and
connected to a drainage hose (see Assembly).
The
appliance
must
be
easily
accessible
for
servicing/maintenance purposes. It is important to leave
a space of at least 35 cm in front of the front panel to
facilitate the cleaning and replacement of the filters (fig.
3).
Checks on delivery
On delivery, check the appliance for any faults before
proceeding with the installation. More specifically:
• firstly remove it from the packaging ensuring that the
name and description shown on the box correspond;
• when the appliance has been removed from the
packaging, check that there is no visible damage then
make sure that the small condensation drainage hose
is present along with the instruction manual.
ENGLISH
35
0
3
28
5
35
0
2
20
Summary of Contents for VORT HR 200
Page 27: ...clean the heat exchanger re t the heat exchanger gs 34 35 36 ENGLISH 31 32 33 27 34 35 36...
Page 34: ...34 NOTE...
Page 35: ...35...
