Problems during operation
Important information on eco-
compatible disposal
I
N CERTAIN EUROPEAN UNION COUNTRIES THIS
PRODUCT DOES NOT FALL WITHIN THE
REQUIREMENTS OF THE NATIONAL LAWS
IMPLEMENTING DIRECTIVE RAEE, AND IN THESE
COUNTRIES THE PRODUCT IS NOT SUBJECT TO
SEPARATE DISPOSAL OPERATIONS AT THE END
OF ITS WORKING LIFE.
This product complies with European Directive
2002/96/EC.
At the end of its useful life, the product,
marked with the crossed out wheeled
bin, must be disposed of separately
from urban waste. It must be taken to a
differentiated disposal centre for
electrical and electronic appliances or
be returned to the retailer when a new
equivalent appliance is bought.
Subject to current legislation on waste disposal, the
user is legally responsible for taking the appliance at
the end of its useful life to a suitable disposal centre.
Appropriate differentiated waste collection for
subsequent recycling, treatment and environment-
friendly disposal of discarded equipment helps to
prevent possible negative environmental and health
effects and encourages recycling of the component
materials of the equipment.
For further information about available waste disposal
systems, contact your local waste disposal service or
the shop where you bought the product.
The manufacturers and importers comply with their
responsibility
for
recycling,
treating,
and
environmentally compatible disposal of waste both
directly and collectively
Type of problem
Probable cause
Action
1.
Safety system
not working
•
Faulty power supply
•
Faulty electrical
component
•
Electrician needed
•
Replace component
•
Help needed
2.
Poor air flow
•
Dirty filter
•
Worn belt
•
Slack belt
•
Fan blades rotating in
wrong direction
•
Exccessive appliance
load loss
•
Vents closed
•
Replace or clean filter
•
Replace belt
•
Adjust drive system
•
Connect motor
correctly
•
Check the design and/or
appliance
•
Modification to fan
section needed
•
Open the vents and
check operating function
3.
Excessive
air flow
•
Appliance load loss
less than nominal
•
Missing component
(filter?)
•
Inspection panel open
•
Adjust vents and
check operating
function
•
Check the design
and/or appliance
•
Modification to drive
system needed
•
Check inside
appliance and fit
missing components
•
Close inspection
panel
4.
Excessive
noise and/or
vibration
•
Fan or motor bearings
worn
•
Fan vibration damper
too compressed
•
Unsuitable vibration
damper supports
•
Too much play in
rotating components
•
Rotating components
not properly fixed on
shaft (blades and/or
pulley)
•
Pulley out of alignment
•
Foreign bodies
interfering with rotating
components
•
Drive system protective
cover not properly fitted
•
Panel screws loose
•
Power supply missing
one phase
•
Incorrect mains
voltage
•
Replace bearings
•
Reposition fan
•
Help needed
•
Help needed
•
Balance or replace
rotating components
•
Help needed
•
Fully tighten the screws
on fan blades and pulley
•
Align the pulley and
fully tighten the
screws
•
Clean inside the
appliance
•
Fully tighten fixing
screws
•
Carefully tighten the
panel screws without
bending the panels
•
Check terminal
connections and
tighten if required
•
Compare voltage with
that shown on ID
plate
20
ENGLISH
