Voom Technologies, Inc. © 2007-2013 Proprietary
www.voomtech.com
6 Button Interface
The button control panel and the LCD are designed to be the normal user
interface. The LCD is used to display each of the menu items, the current
operating state, the progress of the current command, and to acknowledge the
command status information. The button panel consists of the following three
buttons:
Button
Function
Description
Yellow
Menu
This button is designed to step through each of the
menu or parameter items. It always steps in a
forward direction.
Green
Enter
This button is designed to either select a menu or
parameter item, or acknowledge status information.
Red
Cancel
This button is designed to either abort the entering of
a new command or the execution of the previous
command.
The button command menu is organized into a series of levels and parameter
values. When displayed, the command information is displayed on the top line of
the LCD and the parameter information on the next line. The level information is
separated from the command information using a colon (e.g., [1:System Test]
refers to level 1, and a command of “System Test”). Each of the parameters
associated with a particular command (e.g., Wipe Enabled, Wipe Disabled) are
displayed under the command once it has been selected. The prompting
hierarchy used to organize the set of supported commands follows:
Level
Prompt
Description
1
System Test
Perform a system test.
2
Clone Drive
Perform a clone drive operation.
SHA Disabled
Disables the verification of each target drive
after the clone operation has finished (default).
SHA Re-Verify
Enables the verification of each target drive after
the clone operation has finished.
Wipe Enabled
Enables wiping the unused area of a target drive
(default).
Wipe Disabled
Disables wiping the unused area of a target
drive.
3
Verify Drives
Verify all drives contain the same data.
4
Wipe Drives
Perform a wipe drive operation.
5
Remove HPA
Remove HPA from target drives.
6
Remove DCO
Remove DCO from target drives.
Whenever commands are entered from the button control panel, all status
information must be acknowledged by the operator. A special arrow character
11
