Volvo Ingersoll Rand SD-116 TF Series, Operator'S Manual

Page: 81 / 300

OPERATING INSTRUCTIONS SECTION 4
SD-116F/DX/122D/F/DX/160F/DX/190DX/200F/DX 4-17
Raising the Operator Platform
Normally, it will not be necessary to raise the operator platform. All routine maintenance
procedures and fluid checks can be made with the platform in the lowered position. However,
if access to components under the operator’s platform is required, use the following procedure
to raise the operator’s platform.
WARNING
!
Crush area.
Can cause severe injury or death.
Stay clear when raising or lowering the operator platform.
1. Shut off the engine.
2. Remove thumb screws (1, Figure 4-20) from each side of the step assembly
(2).
Figure 4-20
3. Lift up on the step assembly (2, Figure 4-20) until the pins in the step assembly
can be disengaged from the slots in the battery box (3). Pull outward on the
step assembly and carefully lower it to the ground.
4. If not already assembled, install lever (1, Figure 4-21) in jack (3) and secure
with cotter pin (2).