Volvo Ingersoll Rand SD-116 TF Series, Operator'S Manual

Page: 67 / 300

OPERATING INSTRUCTIONS SECTION 4
SD-116F/DX/122D/F/DX/160F/DX/190DX/200F/DX 4-3
PRE-START CHECKS / VERIFICATIONS
Checks and verifications of overall machine must be performed prior to starting. Additional
steps are listed in the 10 hour daily routine maintenance. Check the following before starting:
1. Fuel tank and fuel lines for any leaks.
2. Condition of engine and machine.
3. Bolted assemblies for tightness.
4. Entire machine for any loose, worn or missing parts. Replace as needed.
5. Fluid lines, hoses, fittings, filler openings, drain plugs, pressure caps, drum,
muffler, engine safety shrouds and area under the machine for any signs of
leakage.
WARNING
!
Injury can occur when removing the radiator cap.
Steam or fluid escaping from the radiator can burn. Rust inhibitor
contains alkali. Avoid contact with skin and eyes.
Always shut down the engine and allow it to cool down before removing
the radiator cap. Remove cap slowly to relieve pressure. Avoid contact
with steam or escaping fluid.
6. Check engine coolant level in the coolant recovery bottle (1, Figure 4-1).
Coolant level should be at the COLD level mark if the engine is cold or at the
HOT level if the engine is at operating temperature. If required, add a mixture
of 50% coolant and water to bring coolant to the proper level.
Figure 4-1
.