Volvo Ingersoll Rand SD-116 TF Series, Operator'S Manual

Page: 34 / 300

SECTION 1 SAFETY
1-10 SD-116F/DX/122D/F/DX/160F/DX/190DX/200F/DX
COVER OR TAPE all openings which - for safety and functional reasons - must be protected
against water, steam or detergent penetration before cleaning the machine with water, steam
jet (high pressure cleaning) or detergents. Special care must be taken with electric motors and
switch gear cabinets.
ENSURE during cleaning of the machine that temperature sensors do not come into contact
with hot cleaning agents.
REMOVE all covers and tapes applied for that purpose after cleaning machine.
EXAMINE all fuel, lubricant, and hydraulic fluid lines for leaks, loose connections, chafe marks
and damage after cleaning.
REPAIR or REPLACE defective parts immediately.
TIGHTEN any screwed connections that have been loosened during maintenance and repair.
REPLACE any safety devices removed for setup, maintenance or repair purposes and
checked immediately upon completion of the maintenance and repair work.
ENSURE that all consumables and replaced parts are disposed of safely and with minimum
environmental impact.
AVOID, whenever possible, servicing, cleaning, or examining the compactor with the engine
running.
AVOID, whenever possible, servicing or providing maintenance to the compactor unless the
drum and wheels are adequately chocked, the articulation lock bar/lock pin is in the locked
position, and parking brake is applied.
NEVER fill the fuel tank with the engine running, while near an open flame, or while smoking.
ALWAYS wipe up any spilled fuel.
DO NOT alter the engine governor settings from those indicated in the engine manual and the
engine option plate.
ALWAYS replace damaged or lost decals. Refer to the parts manual for the proper location
and part number for all decals.
ENSURE the safe operation, optimum performance and safety of your warranty by using only
genuine Ingersoll Rand replacement parts.
DISCONNECT the battery cables when working on the electrical system or when welding on
the compactor.
BE SURE the battery area is well ventilated (clear of fumes) should it be necessary to connect
a jump battery or battery charger. Fumes from the battery can ignite by a spark and explode.
BE SURE the battery charger is “Off” when making the connections if battery charging is
required.
USE only original fuses with the specified current rating. Switch off the machine immediately
if trouble occurs in the electrical system.
WORK on the electrical system or equipment may only be carried out by a skilled electrician
or by specially instructed personnel under the control and supervision of an electrician and in
accordance with the applicable electrical engineering.