VOLTCRAFT CPPS-320-42, Operating Instructions Manual

Page: 64 / 140

64
18. ProTECTIVE mEASurES
The power unit has several integrated automatic protective measures that protect the power unit from damage. The
activated protective measures are displayed with letter codes and the DC output is switched off for safety reasons at
the same time.
when a protective measures is active, the consumer must be switched off and disconnected from
the power unit immediately.
To reactivate the output, switch off the power unit. Wait until all displays have gone out. Switch on the power unit
again. The power unit should work normally again. Where this is not the case, please contact our customer service.
The following displays are possible:
a) over-voltage protection
• A higher external voltage than provided by the power unit was determined at the DC output.
The output is switched off.
• The current levels for switching off are listed in the technical data.
b) overheating protection
• The integrated temperature sensor determined that the system temperature is too high. To
prevent overheating, the output is switched off.
• Turn off the power unit and let it cool down for at least 30 minutes.After switching it on,
check if the fan or venitlation apertures are blocked. During the start-up self-test stage, the
fan must start up audibly. Where this is not the case, please contact our customer service.
c) overload protection
• In case of overload at the DC output, the power limitation is usually switched on. If this is not
the case, the second protective function becomes active.
• Switch off the power unit at once when this warning message appears and check the
connection data of the consumer. Remove the consumer from the power unit’s DC output.
• Switch on the power unit again and check its function. If the error message remains on,
please contact our customer service.