VOLTCRAFT CPPS-320-42, Operating Instructions Manual

Page: 49 / 140

49
10. “PrESET” mEmory LoCATIoN oPErATIoN
Three fixed voltages including the current settings can be directly selected via the preset function in the device. All
three memory locations ( PrESET 1, 2, 3) are preset by the factory.
Memory
Type PRESET 1 PRESET 2 PRESET 3
Voltage Current Voltage Current Voltage Current
CPPS-320-42 5 V Maximum 13.8 V Maximum 20 V Maximum
CPPS-320-84 5 V Maximum 13.8 V Maximum 20 V Maximum
Please ensure that no consumers are connected.
The data memory can be set via the software provided. Please also note the chapter “Control with PC
software“.
1. Press any selection button PrESET 1, 2, 3 (8). The button lights up and the preset values are indicated in the
display (2).
2. You can change the preset voltage and current values according to your needs. The output voltage can be
changed at the VoLTAgE setting controller (4) and the output current at the CurrENT (5) setting controller.
If you change the preset voltage and current values, these values are stored, if the laboratory
power supply is switched off. Always test the values set before connecting a consumer.
3. Press the ShIfT (8) button and then any selection button PrESET 1, 2, 3 (8). To test the preset values. The
preset values are indicated in the display (2). The display switches back to normal display after approximately
2 seconds.
Read the chapter “Resetting the values set” to reset the values set to the factory settings.