If the service or the inspection was not performed by a Volkswagen dealership, the display can be
reset as follows:
Vehicles with analogue instrument cluster.
Switch off the ignition.
Press and hold the
button in the instrument cluster
⇒
Instrument cluster .
Switch on the ignition again.
Release the
button when one of the following messages appears on the instrument cluster
display: Reset oil service? or Reset inspection?.
Press the
button on the instrument cluster
⇒
Instrument cluster to confirm.
Vehicles with digital instrument cluster.
The service interval display can be reset only via the Service menu
⇒
Service menu .
Do not reset the service interval display between service intervals otherwise incorrect data will be
shown.
If the oil change service was manually reset, the service interval display then also changes to a fixed
service interval in vehicles with flexible oil change service.
The service message will disappear after a few seconds when the engine is running, or when the
button on the wiper lever or the
button on the multifunction steering wheel is pressed
⇒
Operating the instrument cluster .
If the 12-volt vehicle battery was disconnected for long periods in vehicles with flexible service, the
system cannot calculate the time at which the next service is due. The information shown in the
service interval display may therefore be incorrect. In this case, please observe the maximum
permissible service intervals
⇒
Service .
Operating the instrument cluster
Introduction
This chapter contains information on the followingsubjects:
⇒
Operating using the wiper lever
⇒
Operating using the multifunction steering wheel
⇒
Button for driver assist systems
Some menu options can be accessed only when the vehicle is stationary.
