Road speed sender -G68-
No signal
Road speed sender -G68- defective - Read measured value block =>page
; display group number 002
1) One of these displays appears in addition to relevant component.
2) First check connections for contact corrosion or water ingress and renew if necessary. If solenoid faults
are displayed then especially check the 10 pin connector on gearbox between valve body conductor strip and
wiring loom.
V.A.G 1551 print-out
Possible cause of fault
Rectifying fault
00293
Multi-function switch -F125-
Wiring open circuit
- First check multi-function switch
connector for contact corrosion or
water ingress, renew if necessary
=>Page
Undefined switch condition
Multi-function switch -F125- defec‐
tive
- Read measured value block
=>Page
ber 001
00297
Wiring open circuit
- First check sender connector for
contact corrosion or water ingress,
Gearbox speed sender
-G38-
No signal1)
Gearbox speed sender -G38- defec‐
tive
- Perform electrical check =>from
page
Implausible signal1)
If the control unit recognises an im‐
plausible signal, the connectors for
gearbox speed sender -G38- and
road speed sender -G68- are inter‐
changed
1) One of these displays appears in addition to relevant component.
V.A.G 1551 print-out
(=> Page
)
Possible cause of fault
Rectifying fault
00300
Wiring open circuit
Gearbox oil temperature sender -G93-1)
No fault type recognised
Gearbox oil temperature
sender -G93- defective
- First check connectors for
contact corrosion or water in‐
gress, renew if necessary. If
the solenoid valves are indi‐
cated as being faulty pay spe‐
cial attention to the 10-pin
connector between conductor
strip/valve chest and wiring
harness on the gearbox.
- Read measured value block
=> Page
number 005
1) A faulty ATF temperature sender is indicated.
V.A.G 1551 print-out
(=> Page
)
Possible cause of fault
Rectifying fault
Golf 1998 ➤
Automatic gearbox 01M self-diagnosis - Edition 10.1997
3.5 - Fault table
23