25
Operating instruction (Detailed)
1)
Upon successful insertion of the batteries in the Handset (if the handset has not previously
paired) the display will be as shown if it has been paired already then go to No 3.
1a)
If display is not as above the handset may well need to be reset before pairing.
Press and Hold “Set” Button, to enter Programing menu
When Set Up is flashing, press and release set to enter Setup Mode.
Press and Release the “Set” button several times until you see CAO displayed.
Then press and release “+” button once to change display to CA1
Press and Release the “Set” button once more to display TESC, handset is now ready to pair.
2) Pairing the Handset to the Fire Control
After fitting the batteries as above (and with the isolator slide switch on the TESC Fire control in
the ON position), simultaneously press and hold the – and + buttons on the fire control (i.e. not
the handset) until the handset makes a noise and the display shows the pattern as shown here.
Hold the handset in one hand so your fingers wrap around the back of the operating buttons area
of the handset. A green unlock light will illuminate when the handset has detected your hand. The
green light must be illuminated in this way for any of the command buttons to accept commands
to operate the fire control. Whilst the display is as shown, and holding the handset as described,
press the “SET” button with the other hand to finish off the pairing of the handset to the Fire
