Vogt P18AL TUBE-ICE, Service Manual

Page: 50 / 88

P18AL Service Manual
MAINTENANCE
3/6/07
7-2
PREVENTATIVE MAINTENANCE FORM
This form can be removed and duplicated for record keeping.
Date: ______________ Model #: ________________________ Serial #: ___________________
The following service performed and checked:
Hour meter reading _______________ , Ambient temperature (inside)_______
°
F
Make-Up water float valve adjusted properly
Water distributors clean and in place
All drains freely draining
Cleaned and flushed water tank
Compressor oil changed
Cleaned and inspected inside compressor crankcase
Changed compressor oil filter
Checked/adjusted compressor belt tension or alignment
Lubricate compressor motor bearings
Check/change cutter gear reducer oil
Check/adjust cutter drive gear meshing
Leak check entire system
Check liquid refrigerant level in receiver
Drained oil from oil trap
Compressor crankcase heater working
Compressor net oil pressure (gage reading less suction)
Motor amps: Compressor ________
Cutter ________ Pump ________
Suction psig (end of freeze) __________
Discharge psig (end of freeze)_____________
Suction psig (end of thaw) __________ Discharge psig (end of thaw) _____________
Compressor water out ____
°
F Tower fan cycles ___ On ___ Off
Ice Production Check
Test
Cycle
Make-up
Water
Temp
Freezing
Time
Min/Sec
Harvest
Time
Min/Sec
First
Ice Out
Min/Sec
All
Ice Out
Min/Sec
Avg.
Hole
Size
Ice lb.
Per Harvest
(estimated)
Ice lb.
Per Day
(estimated)
#1
#2
#3
#4
Comments: _______________________________________________________________________
_________________________________________________________________________________
_________________________________________________________________________________
Name: __________________________________
Ice Making Section
The ice-making section of the Tube-Ice
®
machine should be cleaned at
least twice a year (more often if water conditions cause mineral build-up). Use an approved food-