Procedure
u
To activate replay mode, enter the following at the command-line prompt.
esxtop -R <vm-support_dir_path>
Replay Mode Command-Line Options
You can use replay mode with command-line options.
Table A-18
lists the command-line options available for
esxtop
replay mode.
Table A-18.
Command-Line Options in Replay Mode
Option
Description
R
Path to the vm-support collected snapshot’s directory.
a
Show all statistics. This option overrides configuration file setups and shows all statistics. The
configuration file can be the default
~/.esxtop4rc
configuration file or a user-defined
configuration file.
b
Runs
esxtop
in Batch mode.
c
<filename>
Load a user-defined configuration file. If the
-c
option is not used, the default configuration
filename is ~/.esxtop4rc. Create your own configuration file and specify a different filename
using the
W
single-key interactive command.
d
Specifies the delay between panel updates. The default is five seconds. The minimum is two
seconds. If a delay of less than two seconds is specified, the delay is set to two seconds.
n
Number of iterations
esxtop
updates the display this number of times and then exits.
vSphere Resource Management Guide
98
VMware, Inc.
Summary of Contents for ESX 4.0
