Vmac VR70, Installation Manual

Page: 64 / 80

VMAC
– Vehicle Mounted Air Compressors
Toll Free: 1-888-241-2289
Fax: 1-250-740-3201
62
□
Connect the Throttle Controller’s connector to the foot pedal
assembly.
□
Connect the Throttle Controller
’s remaining connector to the
OEM harness for the foot pedal assembly.
□
Locate the blunt-
cut OEM SEIC wire harness, on the driver’s
side just below the OBDII port (Figure 5.5). You will need to find
the following wires:
•
ignition-switched 12V OEM SEIC circuit CDC64
–
▪
yellow wire with orange stripe on early builds
▪
white wire with blue stripe on later builds
•
tachometer signal OEM SEIC circuit CE913
– blue wire
•
transmission park signal OEM SEIC circuit CLS05
– blue
with grey stripe (marked previously)
•
park brake switch OEM SEIC CMC25
– white wire with
purple stripe
HOOD
SEIC blunt-cut wires
bundle
Figure 5.5
□
Solder and seal the long red
‘KEY SWITCHED 12V’ wire
(coming from the shrink-wrapped diode) to the OEM SEIC circuit
CDC64 yellow with orange stripe wire on early builds, white with
blue stripe wire on later builds, at the blunt-cut harness.