VMAC - Vehicle Mounted Air Compressors
VMAC Technical Support: 888-241-2289
VMAC Knowledge Base: www.kb.vmacair.com
47
To compressor
From AOST
☐
Route the hose along the transmission bell housing (Figure 61).
Figure 61 — Routing the hoses
Install 4th P-clip
above this point
☐
The hose will gradually bend 90° to connect to the fitting on the front of the
AOST.
☐
Apply the split loom to the PTFE tubes.
☐
Route the PTFE tubes along the main discharge hose and connect them to the
AOST.
☐
Secure the PTFE tubes to the main discharge hose as necessary with cable ties.
☐
Connect the 90° fitting on the longest 1/2 in hose to the driver side fitting of
the cooler and route it along the frame to the AOST (Figure 62).
Figure 62 — Connecting the hoses
☐
Secure the hose to the suspension bump stop using the supplied cable ties.
☐
Connect the 90° fitting on the shorter 1/2 in hose to the passenger side of the
cooler and run it up to the oil return fitting on the compressor (Figure 62).
☐
Adjust the hoses and/or the AOST to minimize sharp bends, contact with any
hot, sharp or moving parts, then tighten all fittings and the tank mounts and
straps.
☐
Bundle the hoses together and secure with cable ties.
☐
Move the steering between the left and right lock positions to confirm
adequate clearance.
