VMAC - Vehicle Mounted Air Compressors
VMAC Technical Support: 888-241-2289
VMAC Knowledge Base: www.kb.vmacair.com
75
☐
Remove the plastic trim panel from the doorsill and the kick panel on the driver
side.
☐
Install the control box in a convenient location in the cab, positioned so the wire
harness will reach the compressor. The preferred location is between the driver
side seat and the door.
☐
If using the preferred control box location, route the cables from the control box
along the doorsill, under the trim panel, behind the kick panel and up under the
dash.
☐
If routing the cables along the doorsill, a notch may need to be cut into the sill
where the cable enters from the control box.
☐
Remove the dashboard panel below the steering wheel.
☐
Locate the throttle control under the dash away from moving parts and
positioned so the idle down pressure (IDP) and maximum rpm adjusting screws
are accessible (Figure 116).
Figure 116 — Installing the throttle control
Throttle control
