Vmac RAPTAIR-MF D600007, Installation Manual

Page: 14 / 68

VMAC
– Vehicle Mounted Air Compressors
Toll Free: 1-800-738-8622 Local: 1-250-740-3200
Fax: 1-250-740-3201
12
•
24V: CV mode used for jump starting or charging 24V DC
systems. Use the current control dial to limit the amount of
current.
•
12V: CV mode used for jump starting or charging 12V DC
systems. Use the current control dial to limit the amount of
current.
Before connecting jumper-leads to a battery for jump-
starting, set the current knob to 0% and the voltage to
the desired setting.
If connecting unit to equipment for battery boost or
charge ensure proper voltage setting is selected
before connecting cables. Improper voltage selection
could damage equipment. Also ensure cables are
rated for 300A.
1.5.4 PTO Port Option
The Raptair-MF Multifunction Diesel Drive has provisions for an
optional SAE-A-port power take off under the starter on the exhaust
side of the engine. This is able to power up to a 20HP load through a
serpentine belt and a 12V clutch. Typically this is fitted with a
hydraulic pump and is customizable to your individual needs.
Equipment connected to this must be capable of operating at the port
speed of 2700 RPM. Shaft driven and high inertia loads may require
special considerations; please contact VMAC Tech Support for
details
Due to the many types of equipment that can be connected to the
SAE-A-port, the Raptair Multifunction Diesel Drive controller is
not
able to monitor the load or control the equipment. The system will
monitor the engine RPM and will deactivate the compressor if it falls
below the low RPM threshold for proper generator frequency output.
When choosing equipment, care should be taken to determine
the typical/expected load combinations and duty cycle of your
specific needs so as to not overload the system, as the system
may not be able to maintain air pressure in the reservoir tank.
See section 3.1.1 for PTO installation details
1.5.5 PTO Hydraulic Pump Options
•
5, 8, 10 GPM hydraulic pump @ 3500psi