8
VKB Gunfighter Mk.II Quick
Guide - HARDWARE
Replacing/Installing cams – do this for each axis:
(Refer to pg. 5 on how to access the gimbal)
1. Remove the springs.
2. Unscrew the M4 nut and detach the cam from the gimbal.
Caution
: Do not use the hex key to loosen these screws! Only the nut can withstand the force needed to
loosen the screw. Use the hex key to only counter the rotation.*
3. Pay close attention to the position of the washers between the cam and the bearing!
4. Replace the cam, tighten the M4 nut.
Caution
: Do not use the hex key to tighten these screws! Only the nut can withstand the force needed to
tighten the screw. Use the hex key to only counter the rotation.*
5. Install the springs.
6. When done, assemble in reverse order (pay attention to the washers between the cam and the bearing, as
these washers need to be installed in the same location as identified in step 3 above!)
REFER TO THIS VIDEO IF YOU NEED HELP:
https://www.youtube.com/watch?v=_x6RdEJJ_PM
(Even though the video pertains to the Gladiator Pro, the gimbal design (including cams and springs), is pretty
much the same for the Gunfighter)
*
Stripping the hex screw is not covered under VKB’s manufacturers warranty (excessive force)!