Viz 2110 I/O Module Operating Instructions
7
o
Master Clock –
Specify the
for the Master Clock ID for genlock over IP.
FIGURE 5
•
Video Settings – Specify the Frame Rate, Type
(choose between fielded and progressive options),
Width
and
Height
.
Note: The frame rate selected determines which optional formats are shown in the Live Desktop menus. For
example, selecting 29.97 or 59.94 results in only NTSC format frame rate options being listed.
1.6.3
I/O CHANNELS
As mentioned previously, each SFP
transceiver allows two SMTPE 2110
input connections (for a total of four)
and two outputs to SMTPE 2110.
Inputs 1 and 2, and outputs 1 and 2 are
served by SFP A, while SFP B handles
inputs 3 and 4 and outputs 3 and 4.
The settings for each input and output
are configured individually in the
I/O
Channels
tab of the
Administration
panel, as discussed next.
I
NPUTS
After expanding an input control group,
you will typically checkmark the
Enable
Video
and
Enable Audio
switches.
Then enter values and choose
appropriate settings for the corresponding IP streams in the columns below.
•
Dest(ination) IPv4 Address
–reception multicast IPv4 address
•
Dest(ination) UDP Port
– reception User Diagram Protocol (UDP) port
FIGURE 6
