Important Information
With proper care, Sound Video Systems’ presentation console
will provide you with many years of trouble-free operation.
The projector inside the console is a high-brightness light source. Do
not stare directly into the light and do not allow children to look di-
rectly into the light.
To reduce the risk of fire or electric shock, do not expose this product
to rain or moisture. Do not expose the console to dripping or splash-
ing liquids.
Do not place any object that has an open flame or is filled with liquid
on the console. Avoid keeping beverages on top of the console.
This console has a three-wire grounding-type plug. This plug only fits
into a grounded power outlet or extension cord. Do not remove third
prong or try to fit into a standard outlet. Contact an electrician to
replace outlet if needed.
To prevent tripping hazards and damage to cables, coil any extension
cable that exits the console onto the cable wrap, especially during stor-
age or transport.
Do not plug unnecessary item in auxiliary power outlet. The outlet is
intended for laptop and document camera only. The system and the
additional load may overload the system power surge.
Use caution when attempting to open the rear door of the AV Rover,
as wires are attaching the unit to the rear door. Removing the rear
door without attention to the attached speaker and amplifier wires
will damage the system.
Unit should be moved by authorized adults only; do not allow chil-
dren to move the unit. Do not sit or ride on unit.
Prior to moving unit, remove all equipment and items from on top of
unit and disconnect all electrical cords from wall outlets.
Do not allow equipment to overhang or extend beyond edge of top or
shelves and close all doors and drawers, removing the keys before
moving.
Unlock the casters. PUSH unit, from narrow side only, NEVER
PULL.
Be certain you have clear vision and avoid rough or uneven surfaces
and remove obstacles in your path.
Push at a slow walking pace, applying force to the narrow side.
Troubleshooting
Problem
Check
No picture and no sound or
projector does not start.
System power cord is not plugged into the wall
outlet.
Power to the external connected devices is off.
The selected input mode is wrong.
Cables may have come loose.
External output has not been set on the laptop
computer.
Sound is heard but no pic-
ture appears or picture is
dark.
Cables may have come loose.
“Bright” is set to the minimum position.
Depending on the computer you are using, an
image may not be projected unless the signal
output setting of the computer is switched to the
external output. Refer to the computer’s opera-
tion manual for how to switch its signal output
settings.
Color is faded or poor.
Image adjustments are incorrectly set on the
projector.
Make adjustments of “Color” and “Tint” in
“Picture Mode” (Video Input only)
Video Input system is incorrectly set on the
projector.
Picture is blurred; noise
appears.
Adjust the focus
The projection distance exceeds the focus range.
(Computer Input Only)
Perform “Fine Sync” Adjustments (Phase Ad-
justments)
Noise may appear depending on the computer.
Picture appears but no
sound is heard.
Cables are incorrectly connected
Volume is set to minimum.
The amplifier is not turned on.
11
2
Warnings:
