6
Adjusting a Lopsided Image
If the image is lopsided, rotate one side of the console forward or back-
ward. If that doesn’t resolve the issue, you may need to adjust the keystone.
See projector manual for instructions.
Adjusting the Image
While you’re trying to center the rectangular image, please note that it is not
always possible to get a perfectly shaped image. This is because the screen,
projector, console, and floor are independent, physical variables.
When centering the image stand behind the console.
Using the adjustment pull cord on the side of the console, raise or lower
the image by pulling the cord. Lock it into place by pulling the cord
downward.
Moving the cabinet left or right will adjust the horizontal alignment.
To make the image larger, move the console backward, and likewise
move the console forward to make the image smaller.
The zoom lens will allow you to set the zoom to near maximum. This
will give you the largest image at the shortest distance, leaving a small
portion of the zoom to make final adjustments.
Projector & Combo Installation Instructions
Projector Removal
Remove projector mount by removing the projector face panel and the
projector mount assembly with the security bit provided. Note the adjust-
ment cord configuration and undo from the cleat end. This will allow the
mount assembly to be removed. It may be necessary to disconnect the mi-
crophone cable from the amplifier to completely remove the shelf.
The projector is attached to the projector mount with machine screws
that can be removed with an Phillips head screwdriver. Note the position of
the spacers before removing the projector from the mount. Service can now
be performed on the projector.
Projector Installation
Use T-27 bit (located in accessory package) to remove 8 security screws
that secure back door. Gently remove door from unit (approximately 4 to 5
inches) and disconnect speaker wires from speaker located on rear door.
Feed rope into unit and clear from eyebolt on projection shelf. Leave
rope tied to D-ring.
Use T-20 to remove security plate and projector mount.
Set projector upside down
with lens facing out and away from you.
Align lens in middle of mounting plate, or as close as possible.
Align mounting holes on bottom of projector with slots on mounting
plate.
If projector does not lay flat on mounting plate, use spacers to help level
projector.
Install projector mount assembly and security plate onto rack rails.
Laying system on its back side may facilitate mounting the shelf
.
Loop
rope through eye bolt, back through D-ring, and then out through console
and feed into cleat. Tie knot and make sure that projector has full range of
motion (up and down).
Attach yellow video cable (that is provided) to projector. Plug power cord
from projector and combo to power strip. Connect VGA cable to projector.
Slide cable jacket (provided) over the VGA cable and the laptop audio cable.
Make sure all cords and cables are reconnected before you put power to unit.
If you have any questions or concerns please call Sound Video Systems of
WNY, LLC at (800) 724-0236. Thank you for your business and
enjoy your AV Rover!
Additional 3DAVRover Options
7
SVS-CM2Max
Interactive Whiteboard System Option with
Freeclass and Wizteach Software
SVS-CM2MaxST
Short Throw Interactive Whiteboard System Option
with Freeclass and Wizteach Software
SVS-CM2MaxOS Optional Hand Held Stylus for Onfinity CM2Max
SVS-ROVERPAD Interactive Slate/Tablet
SVS-Lock
Wall Lock Bracket and AVRover Attachment Plates
SVS-DCS
Document Camera Shelf for Additional Work Sur-
face
SVS-PDC
Protective Dust Cover (SVS200 or 3DAVRover)
SVS-3500
Projector Upgrade to 3500 lumens (Short Throw)