D-11049-2, Ver 11
Page 8 of 26
V
IVO
T
AB
™
E
LECTRODE AND
V
IVO
A
MP
™
A
LLIGATOR
C
LIP
A
PPLICATION
After proper skin preparation procedures, VivoTab™ electrodes can be
attached to the skin. The VivoTab™ electrodes are intended for
single use only
and should not be reused to prevent patient cross-contamination and to
ensure good electrode skin contact.
To apply a VivoTab™ Electrode to the skin:
1.
Remove the electrode from its plastic sheet.
Avoid touching the adhesive area of the electrode.
2.
Place the electrode on the skin with the adhesive side down.
Apply gentle pressure on its outer edges. The entire periphery of the
electrode should be in contact with the skin.
3.
Attach the VivoAmp™ alligator clip securely to the appropriate skin
electrode site. The VivoAmp™ alligator clips use spring tension for grip.
Always
use the spring release button on the VivoAmp™ clips when clipping
to or unclipping from skin electrodes (do not pull on the VivoTab
electrodes).
E
AR
T
IP
I
NSERTION
Before starting a test using Insert Earphones ear tips, the ear canal must be
clean, free of damage or disease, and clear of any obstructions to ensure good
continuity between the surface of the ear tip and the tissue of the ear.
1.
Inspect the patient's ear canal for obstructions.
2.
If there is an excessive deposit of earwax, have an authorized healthcare
professional remove the earwax, as defined by local healthcare
regulations.
3.
Check the patient's ear canal and select an ear tip that fits tightly, yet
comfortably, in the patient's ear canal.
4.
Attach the ear tips securely to the ends of the earphone tubes.
5.
Roll the ear tip between two fingers and compress it.
6.
Insert the ear tip slowly into the ear canal: place the red transducer into
the right ear, and the blue transducer into the left ear.
Insert Earphones Tips
2
VivoTab™ Electrode
