2.3.5
External Mount
The ViVOpay VEND III can be mounted directly on a surface (external) or mounted from behind a surface
internal) using a flange bracket. Surface mounting requires the standoff and seal for effective weather proofing.
(
To mount externally
1. Drill four 5.0mm (3/16 inch) holes in the surface where the ViVOpay VEND III will be mounted. Use
the hole spacing shown in
Figure 1
.
Figure 1. Mounting hole dimensions
2. Drill a 20.0mm (3/4 inch) hole or cut an access hole large enough to pass an RJ50 connector in the center
of the area inside the mounting holes.
3. Position the ViVOpay VEND III over the mounting holes and use four M4 screws (not supplied)
long enough to secure the ViVOpay VEND III to the mounting surface.
2.3.6
Internal Mount
The ViVOpay VEND III can be supplied with a bracket designed to install the ViVOpay VEND III in the same
cation as a currency acceptance device.
lo
To mount internally
1. Disconnect power from the vending machine.
2. Open the vending machine to access the currency acceptor mounting locations.
3. Remove the currency acceptor or cover plate. Retain the fasteners for ViVOpay VEND III installation.
Copyright © 2010-2013, International Technologies & Systems Corp. All rights reserved.
Page 11 of 18
