22
DLP
Operation
This section describes the following information about using your projector:
Turning the Audio/Visual (A/V) Equipments On and Off
Focusing and Sizing the Projected Image
Operational Indicator (LED)
Turning the Audio/Visual (A/V) Equipments On and Off
Always turn on the projector and related A/V equipments in the following order.
1. Projector
2. Computer
3. Video source
4. Audio source
Turning the Projector On
1. Plug the power cord into the side of the projector.
2. Plug in the power cord into an electrical outlet.
3. Remove the projector lens cap. (Note 1)
4. Turn on the power switch on the side of the projector.
5. Press the Power button (on either the Remote Control or the Projector Control
Panel) to turn on the lamp. When the Green LED indicator is lit, the projected image
will get full illumination.
6. After the image appears on the screen, adjust the focus and size for the projected
image to fit properly on the screen. Make any necessary image adjustments by
using the on-screen menus.
Note 1:
Remove lens cap before projection and attache the lens cover to the lens when
not using the projector, in order to stop the lens from getting dusty or dirty.
